吉亚新的咖啡组垫片更换

这将向您展示如何消除酿造集团垫圈和安装更换。注意:我们强烈建议从锅炉消耗尽可能多的水在你开始。空的水库,把水池旁边的机器。打开机器,蒸汽的胳膊进入水槽,打开蒸汽旋钮,按酿造开关。当水减缓手臂,倾斜向下沉,直到滴的机器停止。关闭机器。为进一步的细节,参考吉亚下面列出的零件编号的零件图。一步一步的指示在开始之前请阅读整个文档。机器的插头,并确保它是完全冷却之前删除水库,portafilter和滴水托盘。去除蒸汽旋钮(# 22)的机器通过直(您可能需要使用平叶片螺丝刀撬起来。寻找之间的两个小缩进按钮盖(# 21)(对前面的顶部)和机器的平顶(# 23)。 Using a small flat blade screwdriver, pop up and remove the button cover (#21). Remove the two Phillips screws (#42) down under the button cover and the one (#42) down in the center of the water reservoir area. Remove the four 4mm Allen bolts (#35 – pg. 2) from around the group head area underneath – they are located around the area that you would lock the portafilter. You should now be able to lift out the entire boiler assembly (#12, 20, and 24 – pg. 2). Remove the four 5mm Allen bolts (#2 – pg. 2) around the corners of the boiler assembly. Note: The boiler may still contain some water, so have a small towel handy to soak it up. Remove the boiler (#12 & 20) from the retaining ring (#24 – pg. 2) and locate the black gasket (#38 – pg. 2) on the bottom of the lower boiler piece. Remove the gasket and clean off the surfaces in that general area. A stiff brush and some descaler (like Urnex Cleancaf or Durgol Swiss Espresso Descaler) can help to remove tough buildup. Put the new gasket in place. Make sure that it is properly seated. Reassemble the machine. Replace the drip tray and water reservoir. Fill the reservoir and plug the machine in. You should now be able to brew without any leaks.